The Pipe Repair Kit is specifically designed to handle any cracked or punctured pipe, quickly and easily with no additional tools needed. Whether it's a large or small diameter, the pipe repair kit comes in a variety of sizes.          

 

Details:-  81 Illingworth Close, Mitcham, Surrey, CR4 3QF, UK  Tel 020 8648 3866     (We stock all products)

All items posted by recorded post

Solution Graphics



3:- Dura Power Pipe & Hose Wrap Repair Kits (Sets Solid Hard)     


DuraPower Product's Pipe & Hose Repair Kit (Cure to Hard Steel)
 
DuraPower Product's Pipe & Hose Repair Kit is a special resin impregnated tape sealed in foil pouch. Once opened, the tape is simply wrapped a around any surface and will set as hard as steel in about 30 minutes, even under water to stop leaks permanently.
Avaliable sizes
1"  x 30" - £11.99
2" X 60" - £13.99
3" X 108"  - £17.99
4" X 180"  - £23.99
 
 
 
Product's Pipe & Hose Repair Kit - 1" X 30" £11.99
Product's Pipe & Hose Repair Kit - 2" X 60" £13.99
Product's Pipe & Hose Repair Kit - 3" X 108" £17.99
Product's Pipe & Hose Repair Kit - 4" X 180" £23.99
DuraPower Product's Pipe & Hose Repair Kit is a special resin impregnated tape sealed in foil pouch. Once opened, the tape is simply wrapped a around any surface and will set as hard as steel in about 30 minutes, even under water. Its design facilitates repairs in hard to reach areas, such as inside walls or at connectors and fittings without the need to cut pipes. Applied correctly it will adhere to almost any surface and cure in approximately 30 minutes

On copper pipe you should clean the repair area with sand paper and muriatic acid (soldering acid.) then flush with water. This tip is for copper pipe to get a good bond.



Instruction:-
Put on protective gloves supplied with this kit,
Tear open the pouch at the notch.
To speed curing time add enough water (fresh or salt) to cover the tape.
Allow 20 seconds then remove the resin impregnated tape from the foil pouch
apply to a clean surface.
Firmly wrap the tape over the area to be repaired pulling in the direction of the wrap.
Extend the tape at least 2" beyond the break in all directions.
Apply 7 or 8 layers of tape over the break.
To increase strength and bonding continue to tighten and squeeze the tape in the direction of the wrap until it is very tacky.
A second application may be applied, and excess resin may be removed with alcohol or acetone before it cures.

 



DuraPower Product's Patch Kit   "Works on wet surface"

   

DuraPower Product's Patch Kit is a Two-Part epoxy Fiberglass Repair Kit

The Patch Kit is especially designed for flat surfaces, such as tanks, containers, boat hulls, or large diameter pipes. This Special patch is easy to use...no measuring, no mess, and no external clean-up. Just blend the components together in the package and apply to any clean surface...It will cure in approximately 20 minutes- even on wet surfaces.

Key BenefitsDoes not required sun to cure, pre-measured two part epoxy , easy to use no external clean-up, f lat surface repair & pipes



Patch Kit - 4" X 12" £9.99